Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
87/94
Acceptable “000_%1” [CR]
%1
“1Y”-------Filter Exchange time is over value of Filter Message.
“1N”--Filter Exchange time is not over value of Filter Message.
Response
Unacceptable “Error Code” [CR]
9.10.35 CR_FANSPEED Command
Command “CR_FANSPEED” [CR]
Details Get selected Fan Control Speed mode.
Acceptable “000_%1” [CR]
%1
“MAX” ------------------------ Max mode is selected
“NOR” ------------------------ Normal mode is selected
Response
Unacceptable “Error Code” [CR]
9.10.36 CR_SIMPLEMODE Command
Command “CR_SIMPLEMODE” [CR]
Details Get setting status of Simple mode.
Acceptable “000_%1” [CR]
%1
“ON” ------------------------ Simple mode is ON
“OFF” ---------------------- Simple mode is OFF
Response
Unacceptable “Error Code” [CR]
9.10.37 CR_RCODE Command
Command “CR_RCODE” [CR]
Details Get selected Remote Control Code
Acceptable “000_%1” [CR]
%1
“001” --------------------------- Code 1 is selected
“002” --------------------------- Code 2 is selected
“003” --------------------------- Code 3 is selected
“004” --------------------------- Code 4 is selected
“005” --------------------------- Code 5 is selected
“006” --------------------------- Code 6 is selected
“007” --------------------------- Code 7 is selected
“008” --------------------------- Code 8 is selected
Response
Unacceptable “Error Code” [CR]
9.10.38 CR_RSENS Command
Command “CR_RSENS” [CR]
Details Get selected location of infrared remote receiver of remote control
Acceptable “000_%1” [CR]
%1
“BOTH” --------Select both front and back receiver of projector
“TOP” --------- Select only top receiver of projector
“BACK” ------- Select only back receiver of projector
Response
Unacceptable “Error Code” [CR]
9.10.39 CR_RTYPE Command
Command “CR_RTYPE” [CR]
Details Get status of supported Remote Control (IR/RF).

Sanyo PLC-HP7000L Specifications

General

Brand	Sanyo
Model	PLC-HP7000L
Category	Projector
Language	English