Sanyo PLC-HP7000L - CR_SRCINP3 Command; CR_SRCINP4 Command

PLC-HP7000L Expand Serial Command Functional Specifications
70/94
9.7.5 CR_SRCINP3 Command
Command “CR_SRCINP3” [CR]
Details Get Source of INPUT3
Acceptable “000_%1” [CR]
%1
“VIDEO” ----------------------- in Video mode
“S-VIDEO” -------------------- in S-video mode
“YPBPR” ---------------------- in Y,Pb/Cb,Pr/Cr mode
Response
Unacceptable “Error Code” [CR]
9.7.6 CR_SRCINP4 Command
Command “CR_SRCINP4” [CR]
Details Get Source of INPUT4
Acceptable “000_%1” [CR]
%1 “NETWORK” ------------- With PJ-Net attached and the power ON
Response
Unacceptable
“101” [CR] ------------- With PJ-Net attached and the power ON
“103” [CR] ------------- With PJ-Net unattached
“?” [CR] ------------- When unknown command is received.