Sanyo PLC-HP7000L - CR_PIPMODE Command; CR_PIPMAININP Command; CR_PIPSUBINPU Command; CR_PIPSIZE Command

PLC-HP7000L Expand Serial Command Functional Specifications
81/94
9.10.10 CR_PIPMODE Command
Command “CR_PIP” [CR]
Details Get Mode in “Picture in Picture”
Acceptable “000_%1” [CR]
%1
“PINP” ----------------- P in P is selected
“PBYP” ---------------- P by P is selected
Response
Unacceptable “Error Code” [CR]
9.10.11 CR_PIPMAININP Command
Command “CR_PIPMAININP” [CR]
Details Get Input and Source for “Picture in Picture”. (Main picture)
Acceptable “000_%1_%2” [CR]
%1
“1” -------------------- Input1 is selected
“2” -------------------- Input2 is selected
“3” -------------------- Input3 is selected
%2
“DIGITAL” --------------------- DVI Input is selected
“ANALOG --------------------- ANALOG RGB is selected
“VIDEO” ----------------------- Video Input is selected
“S-VIDEO” -------------------- S-VIDEO Input is selected
“YPBPR” ---------------------- Y, Pb/Cb, Pr/Cr Input is selected
“SCART” ---------------------- SCART Input is selected
“HDCP” ----------------------- HDCP Input is selected
“HDMI” ------------------------ HDMI Input is selected
Response
Unacceptable “Error Code” [CR]
9.10.12 CR_PIPSUBINPU Command
Command “CR_PIPSUBINP” [CR]
Details Get Input and Source for “Picture in Picture”. (Sub picture)
Acceptable “000_%1_%2” [CR]
%1
“1” -------------------- Input1 is selected
“2” -------------------- Input2 is selected
“3” -------------------- Input3 is selected
%2
“DIGITAL” --------------------- DVI Input is selected
“ANALOG --------------------- ANALOG RGB is selected
“VIDEO” ----------------------- Video Input is selected
“S-VIDEO” -------------------- S-VIDEO Input is selected
“YPBPR” ---------------------- Y, Pb/Cb, Pr/Cr Input is selected
“SCART” ---------------------- SCART Input is selected
“HDCP” ----------------------- HDCP Input is selected
“HDMI” ------------------------ HDMI Input is selected
Response
Unacceptable “Error Code” [CR]
9.10.13 CR_PIPSIZE Command
Command “CR_PIPSIZE” [CR]
Details Get picture size for “Picture in Picture”. (Sub picture)
Response Acceptable “000_%1_%2” [CR]