Sanyo PLC-HP7000L - CR_DDOTS Command; CR_DLINE Command

PLC-HP7000L Expand Serial Command Functional Specifications
65/94
9.5.6 CR_DDOTS Command
Command “CR_DDOTS” [CR]
Details Get value of Display Dots
Acceptable “000_%1” [CR]
%1
“0100 – nnnn”
(nnnn = Total Dots – Position H)
Response
Unacceptable
“Error Code” [CR] ---- When command is not available in the
given condition (such as being selected input
“?” [CR] -------------------- When unknown command is received
9.5.7 CR_DLINE Command
Command “CR_DLINE” [CR]
Details Get value of Display Line
Acceptable “000_%1” [CR]
%1
“0100 – nnnn”
(nnnn = Total Line – Position V)
Response
Unacceptable
“Error Code” [CR] ---- When command is not available in the
given condition (such as being selected input)
“?” [CR] -------------------- When unknown command is received