Sanyo PLC-HP7000L - CF_HSCALE Command; CF_HPOS Command

PLC-HP7000L Expand Serial Command Functional Specifications
35/94
8.7.5 CF_HSCALE Command
Command “CF_HSCALE_%1” [CR]
%1
“035” ---------------------- +35
“031” ---------------------- +31
：
“002” ---------------------- +2
“001” ---------------------- +1
“000” ---------------------- ±0
“‐01” ---------------------‐1
“‐02” ---------------------‐2
：
“‐31” ---------------------‐31
“‐32” ---------------------‐32
“UP” --------------------- Increment setting value of Hscale by 1
“DN” --------------------- Decrement setting value of Hscale by 1
Details
Set Hscale (Available only in the normal Power ON status)
*When the screen mode is not in “Custom”, projector changes image mode into
Custom by receiving this command.
*When there is no signal detected, projector returns 101 and the command does
not execute.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.7.6 CF_HPOS Command
Command “CF_HPOS_%1” [CR]
%1
“015” --------------------- +15
“014” --------------------- +14
：
“002” --------------------- +2
“001” --------------------- +1
“000” --------------------- ±0
“‐01” ---------------------‐1
“‐02” ---------------------‐2
：
“‐14” ---------------------‐14
“‐15” ---------------------‐15
“UP” --------------------- Increment setting value of Hposition by 1
“DN” --------------------- Decrement setting value of Hposition by 1
Details
Set H Position (Available only in the normal Power ON status)
*When the screen mode is not in “Custom”, projector changes image mode into
Custom by receiving this command.
*When there is no signal detected, projector returns 101 and the command does
not execute.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]