Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
88/94
Acceptable “000_%1” [CR]
%1
“IR” -------- IR
“RF” ------- RF (cannot be returned as this model supports only
IR remote control)
Response
Unacceptable “Error Code” [CR]
9.10.40 CR_P-MANE Command
Command “CR_P-MANE” [CR]
Details Get setting status of Power management
Acceptable “000_%1” [CR]
%1
“OFF” ------------------------ Power Management is disabled
“READY1” -------------------- Power Management is set to
Ready1
“READY2” -------------------- Power Management is set to
Ready2
“SHUTDOWN” ------------ Power Management is set to Shut
Down mode
Response
Unacceptable “Error Code” [CR]
9.10.41 CR_P-MANETIME Command
Command “CR_P-MAETIME” [CR]
Details Get setting time for starting Power Management function
Acceptable “000_%1” [CR]
%1 “001 – 030” ----------------------- 1 to 30 minutes
Response
Unacceptable “Error Code” [CR]
9.10.42 CR_ON-STA Command
Command “CR_ON-STA” [CR]
Details Get Direct on setting status
Acceptable “000_%1” [CR]
%1
“ON” -------------------------- Direct on is active
“OFF” ------------------------ Direct on is inactive
Response
Unacceptable “Error Code” [CR]
9.10.43 CR_POINTER Command
Command “CR_POINTER” [CR]
Details Get setting status of Pointer
Acceptable “000_%a” [CR]
%1
“ARROW” ---------------------Arrow Pointer mode
“FINGER” ---------------------Finger Pointer mode
“LASER” ---------------------- Dot Pointer mode
Response
Unacceptable “Error Code” [CR]
9.10.44 CR_PTIMEMODE Command
Command “CR_PTIMEMODE” [CR]
Details Get setting status of count up/down mode in P-timer
Response Acceptable “000_%a” [CR]

Sanyo PLC-HP7000L Specifications

General

Brand	Sanyo
Model	PLC-HP7000L
Category	Projector
Language	English