Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
27/94
8.5.7 CF_DLINE Command
Command “CF_DLINE_%1” [CR]
%1
“0100-nnnn” ----------- Directly specify setting value of Display Line
“nnnn” indicates maximum value, which is current value of (Total Line - Position V).
“UP” ------------------- Increment setting value of Display Line by 1
“DN” ------------------- Decrement setting value of Display line by 1
Details
Set setting value of Display Line in PC signal (Available only in the normal Power
ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable “000” [CR]
Response
Unacceptable
“101” [CR] --- When input is Video signal
--- When input is no signal
8.5.8 CF_SETPCADJ Command
Command “CF_SETPCADJ_%1” [CR]
%1
None
“EXT11-60”
Details
1. Apply setting value of PC adj. to the projecting image.
Projecting image can be corrected with this command as well as when PC control
command and Screen control command below directly apply its value to the
image. (Available only in the normal Power ON status)
・CF_FSYNC
・CF_TDOTS
・CF_CLAMPPAHSE
・CF_H－POS
・CF_V－POS
・CF_DDOTS
・CF_DLINE
2. When “EXT11-60” is specified in %1, “Ex Mode” (not like XGA1) is displayed in
“SYSTEM” menu.
Acceptable “000” [CR]
Response
Unacceptable
“101” [CR] --- When input is Video signal
--- When input is no signal

Sanyo PLC-HP7000L Specifications

General

Brand	Sanyo
Model	PLC-HP7000L
Category	Projector
Language	English