Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
90/94
%1
“LOCK” ------ PJ is locked
PIN code lock is set to ON1/ON2 on the menu and PJ PIN
code is not entered, therefore PJ is actually locked.
“FREE” ------- PJ is unlocked (either A or B)
A) PJ lock is set to OFF on the menu
B) PJ lock is set to ON1/ON2 on the menu, but PIN code
Lock mode is released because PJ PIN code is entered.
Unacceptable “Error Code” [CR]
9.10.50 CR_PJLOCKMENU Command
Command “CR_PJLOCKMENU” [CR]
Details Get ON/OFF setting status of PIN code lock on menu
Acceptable “000_%1” [CR]
%1
“ON1” -------------------- PIN code lock ON 1 is set on the menu
“ON2” -------------------- PIN code lock ON 2 is set on the menu
“OFF” -------------------- PIN code lock OFF is set on the menu
Response
Unacceptable “Error Code” [CR]
9.10.51 CR_SHUTPROT Command
Command “CR_SHUTPROT” [CR]
Details Get disability state of Side panel and RC key for controlling shutter
Acceptable “000_%1” [CR]
%1
“OFF” ------ RC and Side panel are both valid.
“RC” ------------------------------- RC is invalid
“KEY” ----------------------------- KEY is invalid
“BOTH” ------ RC and Side panel are both invalid.
Response
Unacceptable “Error Code” [CR]
9.10.52 CR_SHUTRELEASE Command
Command “CR_SHUTRELEASE” [CR]
Details Get status of Shutter release key function.
Acceptable “000_%1” [CR]
%1
“ANY”-----------Enable to release Shutter with any key
“SHUTTER” ----- Enable to release Shutter with only
“SHUTTER” key
Response
Unacceptable “Error Code” [CR]
9.10.53 CR_SHUTH Command
Command “CR_SHUTH” [CR]
Details Get time setting to start the shutter management
Acceptable “000_%1” [CR]
%1
“005” -------------------- 5 minutes
“006” -------------------- 6 minutes
:
“479” -------------------- 479 minutes
“480” -------------------- 480 minutes
Response
Unacceptable “Error Code” [CR]

Sanyo PLC-HP7000L Specifications

General

Brand	Sanyo
Model	PLC-HP7000L
Category	Projector
Language	English