Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
56/94
8.9.63 CF_DELAYCTRL Command
Command “CF_DELAYCTRL_%1” [CR]
%1
“OFF”---------- Set Video delay control to OFF
“LOW”---------- Set Video delay control to LOW
“MID”---------- Set Video delay control to MID
“HIGH”---------- Set Video delay control to HIGH
Details
Select the mode of Video delay control
(Valid only when in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.64 CF_TESTPAT Command
Command “CF_TESTPAT_%1” [CR]
%1
“COLOR” ---------------------- Display Color bar
“GRAD1” ---------------------- Display 16step(white→black)
“GRAD2” ---------------------- Display 16step(white←black)
“GRAD3” ---------------------- Display 16step(white↓black)
“GRAD4” ---------------------- Display 16step(white↑black)
“WHITE” ---------------------- Display all white
“BLACK” ---------------------- Display all black
“CROSS” --------------------- Display Cross
“OFF” ---------------------Do not show test pattern display
Details
Execute test pattern display.
(Available only in the normal Power ON status)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.9.65 CF_FDEFAULT Command
Command “CF_FDEFAULT_%1” [CR]
%1 “RST”
Details
Reset to Factory Default setting
(Available only in the normal Power ON status)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]

Sanyo PLC-HP7000L Specifications

General

Brand	Sanyo
Model	PLC-HP7000L
Category	Projector
Language	English