Sanyo PLC-HP7000L - Lamp Command; CF_LAMPH Command; CF_LAMPMODE Command

PLC-HP7000L Expand Serial Command Functional Specifications
39/94
8.8 Lamp Command
8.8.1 CF_LAMPH Command
Command “CF_LAMPH_%1” [CR]
%1 “RST”
Details Reset lamp running time (Available only in the normal Power ON status)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.8.2 CF_LAMPMODE Command
Command “CF_LAMPMODE_%1” [CR]
%1
“NORMAL” ------------------------ Set Lamp status to Normal mode
“ECO1” ------------------------------- Set Lamp status to Eco1 mode
“ECO2” ------------------------------- Set Lamp status to Eco2 mode
“AUTO” ----------------------------- Set Lamp status to Auto mode
Details
Select Lamp mode (Available only in the normal Power ON status)
The value set by this command is stored in EEPROM and the setting remains
effective after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]