EasyManuals Logo

Sanyo PLC-HP7000L Technical Specifications

Sanyo PLC-HP7000L
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
PLC-HP7000L Expand Serial Command Functional Specifications
24/94
8.4.15 CF_IMAGEADJ Command
Command
“CF_IMAGEADJ_%1”[CR]
%1
“RST”------ Reset adjusted value for the Image
“STR1”---- Store current adjusted value to Image 1
“STR2”---- Store current adjusted value to Image 2
“STR3”---- Store current adjusted value to Image 3
“STR4”---- Store current adjusted value to Image 4
“STR5”---- Store current adjusted value to Image 5
“STR6”---- Store current adjusted value to Image 6
“STR7”---- Store current adjusted value to Image 7
“STR8”---- Store current adjusted value to Image 8
“STR9”---- Store current adjusted value to Image 9
“STR10”---- Store current adjusted value to Image 10
Details
Reset or Store adjusted value for Image.
(Available only in the normal Power ON status)
“STR1”-”STR10” corresponds to “Image1”-”Image10” displayed in projector OSD
menu on selecting “Store for adjusted value of Image. The setting value set in
“Image1 to “Image10 is stored and can be retrieved when turning on the
projector again after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.16 CF_APCTRL Command
Command
“CF_APCTRL_%1” [CR]
%1
“L1” ------------------- Set Auto Picture Control to Level 1.
“L2” ------------------- Set Auto Picture Control to Level 2.
“OFF” ---------------- Set Auto Picture Control OFF.
“UP” ----------- The same operation as pressing Up key or Left key
“DN” -----------The same operation as pressing Down key or Right key
Details
Set Auto Picture Control (Available only in the normal Power ON status)
The value set by this command is not stored in the projector’s memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.17 ADVCOL Command
Command
“CF_ADVCOL_%1” [CR]
%1
“AUTO” -------------- Set Advanced color to Auto
“OFF” ----------------- Set Advanced color OFF.
“UP” ----------- The same operation as pressing Up key or Left key
“DN” -----------The same operation as pressing Down key or Right key
*”UP” and “DN” are exactly same operation.
Details
Set Advanced color mode (Available only in the normal Power ON status)
The value set by this command is not stored in the projector’s memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable “000[CR]
Response
Unacceptable “Error Code [CR]

Table of Contents

Other manuals for Sanyo PLC-HP7000L

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-HP7000L and is the answer not in the manual?

Sanyo PLC-HP7000L Specifications

General IconGeneral
BrandSanyo
ModelPLC-HP7000L
CategoryProjector
LanguageEnglish

Related product manuals