EasyManuals Logo

Sanyo PLC-HP7000L Technical Specifications

Sanyo PLC-HP7000L
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
PLC-HP7000L Expand Serial Command Functional Specifications
22/94
8.4.9 CF_WBAL- Command
Command
“CF_WBAL-%1_%2” [CR]
%1
“R” --------- RED
“G” --------- GREEN
“B” --------- BLUE
%2
“000-063”------ Directly specify value of Color selected in %1 of White Balance.
“UP”-------- Increment setting value of Color specified in %1 of White Balance by 1
“DN”------- Decrement setting value of Color specified in %1 of White Balance by 1
Details
Set value of Color specified in %1 of White Balance (Available only in the normal
Power ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable “000” [CR]
Response
Unacceptable
“Error Code”[CR]
8.4.10 CF_COLTEMP Command
Command
“CF_COLTEMP_%1” [CR]
%1
“000” ------------------------------ Xlow
“001”------------------------------- Low
“002”------------------------------- Mid
“003”------------------------------- High
Details
Set Color Temperature
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable “000” [CR]
Response
Unacceptable
“Error Code [CR]
8.4.11 CF_OFFSET- Command
Command
“CF_OFFSET-%1_%2 [CR]
%1
“R” --------- RED
“G” --------- GREEN
“B” --------- BLUE
%2
“000-063”------ Directly specify value of Color selected in %1 of Offset.
“UP”------------ Increment setting value of Color specified in %1 of Offset by 1
“DN”------------ Decrement setting value of Color specified in %1 of Offset by 1
Details
Set value of Color specified in %1 of Offset (Available only in the normal Power ON
status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable “000” [CR]
Response
Unacceptable
“Error Code”[CR]
8.4.12 CF_NZRED Command
Command
“CF_NZRED_%1” [CR]
%1
“OFF” ---------------- Cancel Noise Reduction
“ON” ------------------- Set Noise Reduction
“UP” ----------- The same operation as pressing Up key or Left key
“DN” -----------The same operation as pressing Down key or Right key

Table of Contents

Other manuals for Sanyo PLC-HP7000L

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-HP7000L and is the answer not in the manual?

Sanyo PLC-HP7000L Specifications

General IconGeneral
BrandSanyo
ModelPLC-HP7000L
CategoryProjector
LanguageEnglish

Related product manuals