Section 2: Installation
Page 2-10 HR2 Series Operator Manual
2.4 LOADING THE CARBON RIBBON (cont’d)
3.
Insert the ribbon adapter all the way into the ribbon
rewind core.
When loading the carbon ribbon for the first time, use
the empty ribbon rewind core supplied with the
printer. However, the subsequent ribbon core can be
obtained from the last used up ribbon roll.
4. Press the ribbon unit lever to release the ribbon
unit.
Note:
When loading the carbon ribbon, make sure that the
top cover is fully opened.
5. Hold two corners of the pinch roller unit and pull it
in the arrow direction to unlatch.
6. Lift down the ribbon unit and push the ribbon pinch lever upwards.
To Next Page
Loading...
