Section 2: Installation
HR2 Series Operator Manual Page 2-11
2.4 LOADING THE CARBON RIBBON (cont’d)
7.
Load the carbon ribbon from the right side and make sure it latches into the ribbon supply shaft bearing
firmly.
Push in the ribbon shaft assembly to the right side of the ribbon supply shaft bearing. Then fix the other
side of the ribbon shaft assembly to the left of the ribbon supply shaft bearing. Turn the ribbon shaft until
the cross shape shaft snaps on the groove of the left ribbon supply shaft bearing.
Note:
Use only genuine SATO carbon ribbons for maximum print quality and printer durability.
Align to the cross-shape shaft bearing when
latching the ribbon.
Align to the round shape shaft bearing
when latching the ribbon.
To Next Page
Loading...
