Section 2: Installation
Page 2-12 HR2 Series Operator Manual
2.4 LOADING THE CARBON RIBBON (cont’d)
8.
Load the ribbon rewind core to the rewinding side.
The procedures are same as when loading to the supplying
side.
9. From the ribbon supply shaft bearing, pass the carbon
ribbon underneath the print head assembly to the ribbon
rewind shaft bearing.
Route the ribbon between the ribbon pinch lever and
ribbon roller towards the ribbon rewind core. Then route
the ribbon behind and over the top of the ribbon rewind
core. Paste the leader portion of the carbon ribbon onto the
ribbon rewind core.
To Next Page
Loading...
