Section 3: Operation and Configuration
Page 3-24 HR2 Series Operator Manual
3.7 INTERFACE MODE (Cont’d)
Setting of USB
USB CONFIGURATION
Menu Description
Select the communication protocol.
STATUS4 and STATUS5 are available for selection when USB interface boards
is installed.
The initial value is STATUS4.
When STATUS4 is selected, the printer will proceed directly to INTERFACE
MODE menu.
When STATUS5 is selected, the printer will proceed to ITEM NO CHECK
menu.
Set item number check function.
ENABLE: Item number check is ON
DISABLE: Item number check is OFF
The initial value is DISABLE.
This screen is displayed only when PROTOCOL is set to STATUS5.
Set BCC check function.
ENABLE: BCC check is ON
DISABLE: BCC check is OFF
The initial value is DISABLE.
This screen is displayed only when PROTOCOL is set to STATUS5.
FEED
button
LINE
button
FEED
button
LINE
button
From DATA PORT
or SUB PORT
screen
FEED button
FEED
button
LINE
button
Displayed only
when STATUS5
is set
Proceed to INTERFACE MODE
menu or EXTERNAL DEVICE
screen.
* Press <, > buttons to select item accordingly.
The active arrow icons are displayed on the
screen.
* Press and hold LINE button on each screen
will revert to INTERFACE MODE menu.
To Next Page
Loading...
