SATO HR2 Series - Page 63

Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-23
3.7 INTERFACE MODE (Cont’d)
RS-232C CONFIGURATION
Menu Description
Set item number check function.
ENABLE: Item number check is ON
DISABLE: Item number check is OFF
The initial value is DISABLE.
This screen is displayed only when PROTOCOL is set to STATUS5.
Set BCC check function.
ENABLE: BCC check is ON
DISABLE: BCC check is OFF
The initial value is DISABLE.
This screen is displayed only when PROTOCOL is set to STATUS5.
Setting receive buffer type.
MULTI: Multi buffer
1ITEM: Single item buffer
This screen is displayed only when PROTOCOL is set to READY/BUSY or
XON/XOFF.
The initial value is MULTI.