Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-31
3.10 ADVANCED MODE (Cont’d)
ADVANCED MODE
Menu Description
Enabling/ Disabling the display of command error.
This setting determines the printer motion when detecting a command error.
YES: Stops printing operation when command error is occurred.
NO: Displays a warning icon and continues printing operation.
The initial value is NO.
The printer can be set to perform a check of the print head when printing each
label.
ENABLE: Head check is ON
Select ENABLE and press FEED button will proceed to HEAD CHECK menu.
DISABLE: Head check is OFF
Select DISABLE and press FEED button will proceed directly to EXTERNAL
SIGNAL menu.
The initial value is ENABLE.
If Head Check has been ENABLE, you can specify the print head checking to
be performed unconditionally, or only when barcodes are being printed.
NORMAL: Head check is performed on the entire print head.
BARCODE: Head check is performed only on position where barcodes are
being printed.
The initial value is NORMAL.
This screen is displayed only when HEAD CHECK is set to ENABLE.
Set this feature to enable or disable the printer’s external signal communication
port. If the port is enabled, data can be sent and received using an appropriate
device plugged into the EXT port.
ENABLE: Allowing external signal input/output.
DISABLE: Not allowing external signal input/output.
The initial setting is DISABLE.
Setting the output signal type of PREND.
This screen is displayed only when EXTERNAL SIGNAL is set to ENABLE.
TYPE1, TYPE2, TYPE3 or TYPE4 can be selected.
The initial setting is TYPE4.
Output dispense waiting signal to external pin.
ENABLE: Enables external signal output during waiting dispense.
DISABLE: Disables external signal output during waiting dispense.
This screen is displayed only when EXTERNAL SIGNAL is set to ENABLE.
The initial setting is DISABLE.
Note: Pin 9 or pin 10 can be selected for output in the EXTERNAL DISP PIN
SELECT screen of the Service mode.
Setting the reprint function by external signal (7-pin).
ENABLE: Allowing reprint.
DISABLE: Not allowing reprint.
The initial setting is DISABLE.
To Next Page
Loading...
