Table of Contents
Page vi HR2 Series Operator Manual
7.4.2 Software Specifications ..................................................................................... 7 - 8
7.4.3 TCP/IP Specifications ........................................................................................ 7 - 8
7.4.4 LPD Specifications............................................................................................. 7 - 8
7.4.5 FTP Specifications............................................................................................. 7 - 8
7.4.6 TELNET Specifications...................................................................................... 7 - 9
7.4.7 Setting/Displayed Items ................................................................................... 7 - 10
7.4.8 Socket Connection........................................................................................... 7 - 10
7.4.9 Operating Suggestions .................................................................................... 7 - 11
7.5 External Signal Interface (EXT)................................................................................. 7 - 11
7.5.1 Basic Specifications......................................................................................... 7 - 12
7.5.2 Pin Assignments .............................................................................................. 7 - 13
Appendix 8 - 1
8.1 Positions of Sensors and Options ............................................................................... 8 - 2
8.2 Operation Mode Selection........................................................................................... 8 - 3
8.3 Base Reference Point ................................................................................................. 8 - 4
8.4 Base Reference Point Adjustment .............................................................................. 8 - 5
8.4.1 Adjustment of Print Position............................................................................... 8 - 5
8.4.2 Adjustment of Stop Position When Using Dispenser/ Tear-off .......................... 8 - 6
8.4.3 Adjustment of Stop Position in Tear-off Mode (only for the first label)............... 8 - 7
8.5 Paper End ................................................................................................................... 8 - 8
8.5.1 Paper End Detection during Paper Feed........................................................... 8 - 8
8.5.2 Paper end detection in print motion ................................................................... 8 - 8
8.6 Ribbon End................................................................................................................ 8 - 10
8.7 Rewinder Full ............................................................................................................ 8 - 11
To Next Page
Loading...
