SATO HR2 Series - Page 81

Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-41
3.13 TEST PRINT MODE (Cont’d)
Item name (Print) Item name Description
Head Counter1
Head Counter2/3
Head counter 1, 2,
3
Printing the total usage of print head.
xxxxx.x(km)
Dispenser Counter Dispenser Counter Printing the dispenser usage.
xxxxx.x(km)
Head-Check [All] Head check result Performing head check and printing out its result.
Head check OK: OK
Head check NG: NG
(NG will be highlighted)
F-Pitch Offset(VR) Factory Pitch Off-
set
Printing the factory pitch offset.
x.xx(mm)
Reflective Sensor
Low [Lo<0.4] x.x(V)
High[0.9<Hi-Lo]
x.x(V)
Slice Level Auto
Sensor type Printing this information when reflective sensor (I-Mark)
is selected.
If “Low” is not [Low < 0.4], “Low” will be indicated in
reverse colors.
If “High” is not [0.9 < (High-Low)], “High” will be indicated
in reverse colors.
Transmissive Sensor
GAPx
Low [0.1<Lo<0.6]
x.x(V)
High[0.9<Hi-Lo]
x.x(V)
Slice Level Auto
Sensor type Printing this information when transmissive sensor
(GAP) is selected.
Indicates GAP sensor number in use by “x” in "GAP(x)".
If “Low” is not [0.6 < Low < 1.0], “Low” will be indicated in
reverse color.
If “High” is [0.9 < (High-Low)], “High” will be indicated in
reverse colors.
Data/Sub Port Data/Sub Port con-
nection
LAN ( / RS-232C / USB) / None ( / RS-232C / USB /
LAN)
Pitch(LCD) Print position
adjustment value
Printing the pitch position set through LCD screen.
±3.75(mm)
Offset(LCD) Stop position
adjustment value
Printing the offset position set through LCD screen.
±3.75(mm)
Darkness(LCD) Darkness adjust-
ment value
Printing the print darkness set through LCD screen
00~99
Print Speed Print Speed 1.0 ~ 4.0 (inch/s)
Print Darkness Print Darkness/
Range
Printing the print darkness and darkness range.
1A, 2A, 3A, 4A, 5A, 1B, 2B, 3B, 4B, 5B
Print Offset Print Offset Printing the offset position for printing.
For 12dot/mm: (H)±2400 (V)±672(dot)
For 24dot/mm: (H)±4800 (V)±1344(dot)
Operation Mode Operation mode
setting
Printing the name of selected operation mode.
Continuous mode: Continuous
Dispense mode: Dispense
Tear-off mode: Tear Off