SCHWIND Amaris 500E - Planning SCHWIND CAM Treatments

USER MANUAL (Instruction for Use) SW 6.1
Treatment Selection
Version 6.1.6 dated 2020-01-31 EN Page 141 of 201
8.2 Planning SCHWIND CAM Treatments
The abbreviation CAM means Custom Ablation Manager. With the SCHWIND AMARIS, all the
treatments are SCHWIND CAM guided.
The software consists of three modules:
 ORK-CAM- the module for refractive treatments,
 PresbyMAX- the module for presbyopic treatments,
 PTK with which aspheric and refraction neutral PTK profiles can be planned.
IMPORTANT NOTE
This SCHWIND CAM software, especially developed for the AMARIS, is NOT
part of the AMARIS manual. Please refer to a separate User Manual for
SCHWIND Custom Ablation Manager.
8.2.1 Planning of new Treatments
By pressing the <New> button in the Main menu the SCHWIND CAM software will be opened
and will allow you to enter all the patient data and type of treatment by selecting one of the
modules, e.g ORK-CAM. (Please refer to the user manual of the SCHWIND Custom Ablation
Manager.)
After the treatment planning is completed, the summary page (see Figure 8-4) is displayed
automatically and the user has the possibility to directly proceed to the treatment screen of the
AMARIS software.
IMPORTANT NOTE
The “Summary Page” is only for information purposes and it is not possible to
make further changes.
To print out the “Summary Page” press the <Print> button.
To select another patient or another eye press the <Cancel> button.
To start the treatment, press the <Start Treatment> button. The calculation of the shot positions
out of the imported ablation volume and the current fluence value of the laser will take a few
seconds.
8.2.2 Import of SCHWIND CAM Treatments
By pressing the <Import> button in the Main menu you will be able to import treatment files
which have been created with the SCHWIND-CAM software installed on a diagnostic workstation
(Corneal Wavefront Analyzer or Ocular Wavefront Analyzer).
A standard path from which the files should be imported can be defined in the general settings
Menu of the SCHWIND AMARIS Application software.