EasyManua.ls Logo

SCHWIND Amaris 500E - In Case of Emergency

Default Icon
201 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USER MANUAL (Instruction for Use) SW 6.1
Safety
Version 6.1.6 dated 2020-01-31 EN Page 35 of 201
2.8 In Case of Emergency
In chapter 2.6 Dangers Resulting from Laser Operation, dangers are listed which could occur
during laser operation. The risk of an emergency is lowered to a minimum by the technical design
of the system and the organizational measures taken by the manufacturer (refer to chapter 2.4
Manufacturer’s Responsibility).
If a danger for the service personnel and the patient during the laser operation should arise
despite the protective measures of the manufacturer, the following steps have to be taken:
Gas leak (laser operating gas)
o Open the windows.
o Shut down the laser system and switch off the device using the emergency stop switch.
o All personnel must leave the room.
o Inform the service department of SCHWIND eye-tech-solutions or the customer service
of your distributor (see Service Hotline).
Other dangerous situations
o Switch off the laser system using the emergency stop switch.
o Bring the patients and the service personnel in a safe environment.
o Inform the service department of SCHWIND eye-tech-solutions or the customer service
of your distributor (see Service Hotline).
Accident situation
In the case of a work accident resulting in injury to the eye or skin from laser radiation of a patient
or the service personnel, after carrying out any medical care, a medical professional must
perform a thorough examination.
An accident notice is to be submitted to the responsible supervisory authority. A copy of this
message is to be sent to SCHWIND eye-tech-solutions GmbH. You will find a sample of the
damage report in your Medical Apparatus Book in chapter 9.
Observe the requirements of Standard IEC 60825-1

Table of Contents

Related product manuals