EasyManua.ls Logo

SCHWIND Amaris 500E - Initial Installation; Start-Up; Relocation of the Excimer Laser System

Default Icon
201 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USER MANUAL (Instruction for Use) SW 6.1
Installation
Version 6.1.6 dated 2020-01-31 EN Page 91 of 201
5.5 Initial Installation / Start-Up
Unpacking, initial installation/start-up and instruction in operating the device according to MPG
will be performed by a service technician/engineer of SCHWIND eye-tech solutions or authorized
Representative.
The service technician inspects the room for necessary installations (dimensions, electrical
connection, security regulations and air-condition refer to chapter 5.2, Room and Installation
Requirements).
He confirms the correspondence in the inspection protocol and connects the system to the power
supply. After a system check and necessary adjustments, he performs operational tests.
CAUTION
Do not perform the initial installation of the software and/or device(s).
The customer is not allowed to perform the electrical connection (main supply
and interlock) of the device during initial start-up or to perform the initial
installation/start-up of the software / device.
Unauthorized starting of installation or use of the device invalidates the
warranty.
Trained service personnel of SCHWIND eye-tech-solutions will perform the
initial installation/start-up of the SCHWIND AMARIS and connection with a
patient bed, as well as instruction in operating the system.
Please contact the Service Department of SCHWIND eye-tech-solutions to
organize the initial installation of the software and/or device(s).
WARNING!
Risk of injury!
While adjusting the SCHWIND AMARIS excimer laser and a patient bed, do not
grasp into the motion range of the patient bed. Make sure to keep the wheeling
area of the patient bed free of any objects.
Please refer to further installation notes contained in chapter 5.1.
5.6 Relocation of the Excimer Laser System
If you intend to transport the excimer laser to a new location, please inform the service
department of SCHWIND eye-tech-solutions or the customer service of your distributor (see
Service Hotline).
CAUTION
Damage of device!
The relocation of the excimer laser and the patient bed may only be carried
out by service technician of SCHWIND eye-tech-solutions or by SCHWIND
authorized personnel.

Table of Contents

Related product manuals