SCHWIND Amaris 500E - System Software Requirements; SCHWIND CAM Software

USER MANUAL (Instruction for Use) SW 6.1
Installation
Version 6.1.6 dated 2020-01-31 EN Page 86 of 201
5.3 System Software Requirements
5.3.1 SCHWIND CAM Software
 The AMARIS application software and the SCHWIND CAM software or any of its modules
must only be used on computers conforming to the requirements established by the IEC
60601-1 standard.
 Furthermore, the SCHWIND CAM software or any of its modules have to be installed and
used only on computers officially approved by SCHWIND eye-tech-solutions.
 SCHWIND eye-tech-solutions does not assume any liability for installing or using the
SCHWIND CAM software or any of its modules on computers not officially approved by
SCHWIND eye-tech-solutions.
Further system requirements for the SCHWIND CAM are listed in the Use Manual of the
SCHWIND CAM.
IMPORTANT NOTE
External mass-storage devices (e.g. external drive, card reader & memory card
or USB-harddisk) may be supplied only via the USB interface of the PC or be
operated with a power-supply pack corresponding to the regulation IEC 60601-
1 for medical products.
IMPORTANT NOTE
Data carriers like CD-ROM and memory cards must be absolutely protected
from heat, direct sunlight and electromagnetic interference fields!