INTRODUCTION
INTRODUCTION
This shop manual covers the following BRP made 2009 Sea-Doo watercraft models.
MODEL COLOR ENGINE MODEL NUMBER
GTX Limited iS
Topaz mist metallic
1503 HO (255 HP)
189A, 189B
RXT iS
Bright yellow
1503 HO (255 HP
)
349A, 349B
The information and component/system descrip-
tions contained in this manual are correct at time
of writing. BRP however, maintains a policy of
continuous improvement of its products without
imposing upon itself any obligation to install them
on products previously manufactured.
Duetolatec
hanges, there may be some differ-
ences betwe
en the manufactured product and the
descriptio
n and/or specifications in this document.
BRP reserves the right at any time to discontinue
or change specifications, designs, features, mod-
els or equipment without incurring obligation.
VEHICLE INFORMATION
HULL IDENTIFICATION NUMBER
(H.I.N.)
The hull identification number is composed of 12
digits:
YDV
12345
L
495
Model year
Year of production
Month of production
Serial number (a letter may also be used as a digit)
Manufacturer
It is located on footboard at the rear of watercraft.
smr2009-011-001_a
1. Hull Identification Number (H.I.N.)
ENGINE IDENTIFICATION
NUMBER (E.I.N.)
The Engine Id
entification Number is located on
front end of t
he engine.
F18D03A
1
1. Engine Identification Number (E.I.N.)
WORKING ON WATERCRAFT
To work on watercraft, securely install it on a
stand. Thus, if access is needed to water inlet
area, it will be easy to slide underneath water-
craft.
The
LIFTING STRAP (P/N 529 036 171) MUST be
used to install watercraft on a stand.
NOTICE
Using any other lifting strap kit than
the recommended one will cause damages to
the vehicle. Bumpers will be tear off and their
replacement will be required.
X smr2009-011
To Next Page
Loading...
Need help?
General