INTRODUCTION
Threadlocker Application for Case-In
Components (Metallic Gaskets)
A00A3VA
1
1. Proper str
ength Loctite
1. Clean inner housing diameter and outer gasket
diameter.
2. Spray hou
sing and gasket with
LOCTITE PRIMER
N (P/N 293
800 041)
.
3. Apply a strip of proper strength Loctite on lead-
ing edge of outer metallic gasket diameter.
NOTE: Any Loctite product can be used here. A
low strength liquid is recommended as normal
strength and gap are required.
4. Install
according to standard procedure.
5. Wipe off surplus.
6. Allow it to cure for 30 minutes.
NOTE: N
ormally used on worn-out housings to
preven
t leaking or sliding.
It is generally not necessary to remove gasket
compound applied on outer gasket diameter.
smr2009-011 XIX
To Next Page
Loading...
Need help?
General