SICK FLOWSIC100

Start-up and Parameter Settings
FLOWSIC100 · Operating Instructions · 8012513/YSA5/V 2-1/2016-07 · © SICK Engineering GmbH 115
Subject to change without notice
Installing the USB driver
A special hardware driver is required for communication between SOPAS ET and the
FLOWSIC100 visibility measuring system via USB interface. This must be installed on the
laptop/PC:
 Connect the USB interface cable to the PC.
A message appears on the screen that new hardware has been found.
 Insert the delivered CD in the PC drive and follow the installation instructions.
Fig. 84 Installing the USB driver