SICK microScan3 Core I/O AIDA User Manual

9 Operation
9.1 Safety
DANGER
H
azard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of
non-observance.
b
Maintenance work, alignment work, fault diagnoses, and any changes to the
integration of the protective device in the machine must only be carried out by
qualified personnel.
b
The effectiveness of the protective device must be checked following such work.
NOTE
T
his document does not provide instructions for operating the machine in which the
safety laser scanner is integrated.
9.2 Regular thorough check
The test is intended to ensure that the hazardous area is monitored by the protective
de
vice and any attempted access to the hazardous area is prevented.
b
Carry out the checks specified in the test plan of the manufacturer of the machine
and the operating entity.
9.3 Status indicators
Overview



Figure 64: LEDs
1
Status LEDs
2
Additional LEDs for ON state and OFF state
3
Display
Further topics
•
"D
etailed diagnostics using the display", page 116
•
"Fault indication on the display", page 118
9.3.1 Status LEDs
4 status LEDs are located directly above the display.
9 O
PERATION
106
O P E R A T I N G I N S T R U C T I O N S | microScan3 Core I/O AIDA 8017784/1ELL/2022-01-21 | SICK
Subject to change without notice

SICK microScan3 Core I/O AIDA Specifications

General

Brand	SICK
Model	microScan3 Core I/O AIDA
Category	Scanner
Language	English