SICK microScan3 Core I/O AIDA User Manual

Project
•
Pr
oject name: the same name should be chosen for all devices in the project
•
Application name: this name can be the same for a number of devices in the
project. It highlights that these devices realize an application together, by respond‐
ing to one another for example.
Device information
•
N
ame, identifies the specific device
•
Type code of the safety laser scanner
•
Functional scope of the configuration in the project
•
Functional scope of the configuration in the device
•
Serial number of the safety laser scanner
•
Functionality of the device
•
Part number
•
Revision
Connection
•
C
onnection status
•
Type of connection
Checksums
A c
hecksum is used as a unique identification for a configuration. Using the checksum,
it is possible to work out whether a setup was changed or whether two devices have the
same configuration.
The checksum of the configuration in the project may not match the checksum in the
device, for example if a field geometry has been modified, but not yet transmitted to the
device.
System status
•
Applic
ation status
•
Current notification of the safety laser scanner
•
Configuration date for the configuration in the device
•
Synchronization: shows whether the configuration in Safety Designer and the con‐
figuration in the device are identical
•
Verification status of the configuration in the project
•
Verification status of the configuration in the device
Measurement data
S
hows the measurement data when a device is connected.
Display
S
hows the status of the display and LEDs when a device is connected.
Establishing connection
1.
Check whether the safety laser scanner is connected correctly.
2. Click on Connect in the toolbar.
✓
Safety Designer establishes the connection to the safety laser scanner.
7.3.1 Functional scope
Older versions of the Safety Designer potentially do not support the full functionality of
the latest devices. Vice versa, older devices might not support the full functionality of
the latest Safety Designer.
CONFIGURATION 7
8017784/1ELL/2022-01-21 | SICK O P E R A T I N G I N S T R U C T I O N S | microScan3 Core I/O AIDA
69
Subject to change without notice

SICK microScan3 Core I/O AIDA Specifications

General

Scanning angle	275°
Protection class	IP65
Configuration method	SOPAS ET
Enclosure rating	IP65
Dimensions	102 mm x 152 mm x 106 mm
Scanning range	5.5 m
Protective field range	5.5 m
Number of monitoring cases	128
Supply voltage	24 V DC
Performance level	PL e (ISO 13849-1)
Warning field range	5.5 m
Resolution for safety field	30 mm / 40 mm / 50 mm / 70 mm
Connection type	M12
Protective field resolution	30, 40, 50, 70 mm