SICK S3000 User Manual

Chapter 2 Operating instructions
S3000
12 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8009942/WK81/2012-11-28
Subject to change without notice
On safety
2.3 Correct use
T
he S3000 safety laser scanner must be used only as defined in section 2.2 “Applications
of the device” on page 11. It must be used only by qualified personnel and only on the
machine where it has been installed and initialized by qualified safety personnel in
a
ccordance with these operating instructions. It is only permitted to be used on machines
on which the dangerous state can be stopped immediately by the S3000 and/or it is
possible to prevent the machine being placed in operation.
If the device is used for any other purposes or modified in any way — also during mounting
and installation — any warranty claim against SICK AG shall become void.
2.4 General safety notes and protective measures
Pay attention to the safety notes!
Please observe the following items in order to ensure the correct use of the S3000 safety
laser scanner.
Repair only by authorized persons!
The improper repair of the protective device can result in the loss of the protective
function. The protective device is only allowed to be repaired by the manufacturer or
persons authorized by the manufacturer.
The S3000 safety laser scanner is of laser safety class 1.
Additional measures for screening the laser radiation are not
necessary (eye safe).
 This device meets the norms: IEC 60825-1 as well as CDRH 21 CFR 1040.10 and
1040.11; excluded are deviations due to Laser Notice No. 50, dated 24.06.2007. In the
standards CDRH 21 CFR 1040.10 and 1040.11 the following note is required: “Caution
— use of controls, adjustments or performance of procedures other than those herein
specified may result in hazardous radiation exposure!”
 During the mounting, installation and usage of the S3000, observe the standards and
directives applicable in your country. You will find an overview of the most important
regulations in section 2.6 “Applicable directives and standards” on page 15.
 The national/international rules and regulations apply to the installation, commissioning,
use and periodic technical inspections of the S3000 safety laser scanner, in particular:
– the Machinery Directive 2006/42/EC
– Work Equipment Directive 2009/104/EC
– the work safety regulations/safety rules
– other relevant health and safety regulations
Note

WARNING

SICK S3000 Specifications

General

Brand	SICK
Model	S3000
Category	Scanner
Language	English