SICK S3000

Chapter 1 Operating instructions
S3000
8 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8009942/WK81/2012-11-28
Subject to change without notice
About this document
1 About this document
Please read this chapter carefully before working with this documentation and the S3000.
1.1 Function of this document
These operating instructions are designed to address the technical personnel of the
machine manufacturer or the machine operator in regards to correct mounting, electrical
installation, commissioning, operation and maintenance of the S3000 safety laser
scanner.
These operating instructions do not provide instructions for operating the machine, the
system or the vehicle on which the safety laser scanner is, or will be, integrated.
Information on this is to be found in the appropriate operating instructions for the
machine, the system or the vehicle.
1.2 Target group
These operating instructions are addressed to planning engineers, machine designers and
the operators of machines and systems which are to be protected by one or several S3000
safety laser scanners. They also address people who integrate the S3000 into a machine,
a system or a vehicle, initialize its use, or who are in charge of servicing and maintaining
the device.
1.3 Scope
These operating instructions are original operating instructions.
These operating instructions are only applicable to the S3000 safety laser scanner with
one of the following entries on the type label in the field Operating Instructions:
 8009791 AE V430
 8009791 AE W285
 8009791 AE WK81
This document is part of SICK part number 8009791 (operating instructions “S3000
Safety Laser Scanner” in all available languages).
For the configuration and diagnostics of these devices you require a CDS (Configuration &
Diagnostic Software) version J 3.6.7. To determine the version of your software version,
select the Module Info... option in the Help menu.
Note