SICK S3000

Operating instructions Chapter 5
S3000
8009942/WK81/2012-11-28 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 83
Subject to change without notice
Mounting
Fitting in the vehicle trim
Build the S3000 into the vehicle trim at least such that the unprotected areas are

70 mm and the S3000 projects a maximum of 109 mm beyond the front of the vehicle.
The vehicle may then be accelerated to a velocity of 0.3 m/s within a second.
Additionally protect the area near to the scanner (5 cm wide area in front of the front
screen) using a proximity switch with an acquisition range of 5 cm. Or make the area near
the scanner impassable with a bar or a recess. The vehicle may then be accelerated as
required.
Note that the system must be fitted e.g. in a trim panel without impairing the optical beam
path. The attachment of an additional front screen is thus not allowed. Any slot for the field
of view must be adequately sized (see Fig. 100 in section 12.6 “Dimensional drawings” on
page 159).
If, when observing all necessary safety precautions, you are able to avoid the use of a
restart interlock, you will increase the availability of your system.
Fig.
43
:
Fitting the
S3000
in
the vehicle trim
Note
Recommendation