Siemens AXIOM Iconos R200 - Holding Device for Eight Filters

Accessories
Optional Accessories
AXIOM Iconos R200 AXD3-340.620.13.01.02 53 / 54
Holding device for eight filters
Use For storing a maximum of eight compensating filters
Attaching the
wall holder
◆ Fasten the holder to the wall at working height in a suitable place with the en-
closed wall plugs and screws.
Equipping the
wall holder with
compensating filters
◆ Remove the compensating filters from the packaging.
◆ Turn the filters so that the designation on the filters can normally be read from
above.
◆ Place the filters in the upward-inclined compartments.
Using the
compensating filters
◆ Remove the required compensating filter from the wall holder.
◆ Push the locking lever on the left collimator accessory rail to the left.
◆ Slide the filter into the collimator accesssory rails in the correct direction for
the examination.
– The locking lever on the accessory rail springs back to the right.
◆ Check that the compensating filter sits firmly in the collimator.