AXIOM Iconos R200 AXD3-340.620.13.01.02 13 / 54
Accessories
Optional Accessories
Head support
Application Holder for cranial examinations. Can be adjusted in height, width, and lateral tilt
Attachment ◆ Move the table to the horizontal position.
◆ Loosen both cap screws (1) for attaching the head support to the accessory
rails.
◆ Insert the head support into the accessory rails at the head end or foot end of
the table and move it to the appropriate position.
◆ Tighten the cap screws (1).
◆ Pull the head support to ensure that it is secured properly.
◆ Turn the following cap screws as indicated to permit adjustment of the:
– (2) position from side to side.
– (3) height.
– (4) lateral tilt from 0° to ± 90° (depending on the height setting).
– (5) pads (6) to the width of the patient’s head; turn to the left.
◆ Set the position from side to side.
◆ Tighten the cap screw (2).
◆ Push and pull the head support to ensure that it is seated properly.
◆ Assist the patient in positioning his/her head in the head support.
❏ The patient’s head should make contact with the top pad.
◆ Raise the stabilizing arms to the height required.
◆ Tighten the cap screw (3).
◆ Push and pull on the stabilizing arms to ensure they are seated properly.
◆ Turn the cap screws (5) carefully to the right.
❏ Both padded stabilizing arms will move toward the patient’s head.
2
1
5
1
3
5
1
5
4
1
1
6
6
To Next Page
Loading...
