Accessories
Optional Accessories
54 / 54 AXD3-340.620.13.01.02 Operator Manual
Storing the
compensating filter
in the wall holder
◆ Push the locking lever on the left accessory rail to the left.
– The locking lever on the accessory rail springs back to the right.
◆ Place the filter in a free compartment of the wall holder, turning the filter so
that the designation can normally be read from above.
Three-field templates
Use For exposing the IONTOMAT ionization chambers on the object to be exposed.
The three-field templates are available as a complete set or individually for the fol-
lowing SIDs:
SID: 90 cm - 110 cm
SID: 110cm - 130cm
SID: 130cm - 175cm
SID: 175cm - 220cm
Using the three-field
templates
◆ Push the locking lever on the left accessory rail to the left.
◆ Slide the template into the collimator accessory rail in the correct direction for
exposing the ionization chamber.
– The locking lever on the accessory rail springs to the right.
◆ Check that the template sits firmly in the collimator.
◆ Expose the ionization chambers. To do so, switch on the light of the collima-
tor.
Storing the three-field
templates
◆ Push the locking lever on the left accessory rail to the left.
◆ Pull the template out of the accessory rails.
– The locking lever on the accessory rail springs to the right.
Store the three-field templates in a suitable location.
FFA 90 -110cm 36 - 42 ins. SID
FFA 110 - 130cm
42 - 50 ins. SID
FFA 130 - 175cm 50 -70 ins. SID
FFA 175 - 220cm
70 -90 ins. SID
To Next Page
Loading...
