System Operation
System Settings
16 / 32 AXD3-340.620.13.01.02 Operator Manual
Lowering the tabletop completely with the table vertical
◆ Move the table into a vertical position (+ 90°).
System remote
control console
◆ Press the down button until the tabletop stops automatically at 120 mm from
the floor.
◆ Release the button and press it once again
– The tabletop moves maximum to 40 mm from the floor
– an acoustic signal sounds during the tabletop movement
Tableside control
panel
◆ Press the right
1
button until the tabletop stops automatically at 120 mm from
the floor.
◆ Release the button and press it once again
– The tabletop moves maximum to 40 mm from the floor
– an acoustic signal sounds during the tabletop movement
Warning
If the tabletop is lowered to less than 12 cm above the floor with the table
vertical, it is possible for feet to be crushed.
◆ Make sure before remote operation that no one is in the direct vicinity of the
system.
◆ Avoid a location directly at the table end in the case of tableside operation.
You will hear a warning tone, if the tabletop is lowered to less than 120 mm
above the floor.
◆ Then control the movement with increased caution.
1
Display in horizontal table position
To Next Page
Loading...
