Siemens AXIOM Iconos R200 - Automatic Fluoroscopy Control; Image Reversal; Additional Filter; Collimator Settings

System Overview
Operating and Display Elements
28 / 44 AXD3-340.620.13.01.02 Operator Manual
Automatic fluoroscopy control
❏ Automatic fluoroscopy program 1
❏ Automatic fluoroscopy program 2
❏ Automatic fluoroscopy program 3
❏ Automatic fluoroscopy stop
Image reversal
❏ Right/left image reversal (vertically mirrored)
❏ Top/bottom image reversal (horizontally mirrored)
Additional filter
❏ Select additional Cu filter (0.1 mm, 0.2 mm, 0.3 mm)
Collimator settings
❏ Coordinate switch for adjusting the primary collimator by motor drive (open/
close)
– Rectangular collimation
– Iris (octagonal) collimation in fluoroscopy and DR
❏ Select rectangular or iris (octagonal) primary collimator for manual collimation
❏ Switch light localizer of the primary collimator on/off
❏ Display of graphics for CAREPROFILE (option)
1
2
3
R
R