System Operation
Table of Contents
AXIOM Iconos R200 AXD3-340.620.13.01.02 1 / 32
Operator Manual
System Operation
Chapter: On-Off/Emergency Stop
Switching the system on .................................................................................................... 5
Switching the system off ................................................................................................... 6
Emergency SHUTDOWN button (installed on-site) ............................................................ 6
Standby power supply ........................................................................................................ 6
Standby power supply inside the hospital ............................................................................ 6
Battery-supported standby power supply (optional) ................................................................ 6
Red Emergency STOP button ............................................................................................ 7
Patient rescue ..................................................................................................................... 8
Chapter: Functional and Safety Check
Daily tests ........................................................................................................................... 9
After switching the system on ........................................................................................... 9
Prior to the examination ........................................................................................... 9
During the examination .................................................................................................. 10
Monthly tests ................................................................................................................... 10
Legally required tests ....................................................................................................... 10
Chapter: System Settings
General notes ................................................................................................................... 11
Collision protection / Safety areas ..................................................................................... 11
Operating elements for system positions ........................................................................... 11
Object-dependent system settings ................................................................................... 12
Start positions .............................................................................................................. 12
General notes on error messages ..................................................................................... 12
Behavior of the system settings in the case of a fault ........................................................... 13
To Next Page
Loading...
