Siemens FS20 - Installation in Comfort Housing; Pin Assignments

Mounting and installation of the compact control panels
Battery kit (9 V) [FR]
5
114 | 354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
5.8.2 Installation in Comfort housing
Figure 52: Mounting of battery kit FCA2010-F1 in Comfort housing
1 Battery, 9 V block type E
2 Fixing screws
3 Battery holder
X1 Battery kit connection (9 V)
Mounting steps
1. Position the battery holder (3) to the left of the power supply.
2. Fasten the battery holder using the two screws (2).
3. Connect the cable of the battery kit according to the pin assignment.
4. Insert the battery (1). Observe correct polarity.
5.8.3 Pin assignments
Connecting the battery kit to the periphery board and the fire terminal
board
X1 Designation Connection
5 3SRC+ Positive pole, red
6 3SRC- Negative connector, blue
Table 1: Pin assignment for terminal X1 on the periphery board and the fire terminal board
3
2
1
X1