Siemens FS20 - Installing the Carrier (19, Card Cage); Installation

Mounting and installation FC20
80
Installing the carrier (19", card cage)
6
274 | 354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
6.4 Installing the carrier (19", card cage)
6.4.1 Installation
The carrier (19", card cage) FHA2023-A1 with the installed card cages (5 slots) or
the DIN rails is an extension for additional module bus cards and I/O cards and
also serves as a carrier for small modules or relays. A maximum of three carriers
(19", card cage) can be installed in the FC2080.
Figure 147: Installing the carrier (19", card cage) FHA2023-A1
1 Mounting holes in rear frame
2 Mounting holes in the carrier (19", card cage), height distance 266.7 mm
3 4 fixing screws M6 x 12 with cage nuts
4 Carrier (19", card cage) with installed card cage (5 slots)
1. Install the prepared carrier (19", card cage) (4) on the rear frame (1) with four
fastening screws and cage nuts (3).
2. Wire up the card cages (5 slots) according to the allocation plan of the
respective module bus cards.
4
321