Mounting and installation of the compact control panels
5
167 |
Building Technologies
1. Remove the housing cover of the card cage (2) by loosening the four fixing
screws (1).
2. Insert the module bus card required (3) into the slot required as shown in the
figure.
3. Ensure that the module bus cards are held correctly in the guides (4).
4. Once all the module bus cards required have been installed, fit the housing
cover (2) of the card cage (5) by fastening the four screws (1).
5. Wire the module bus cards according to the pin assignment below.
5.19.2 Pin assignments
5.19.2.1 Views of card cage (2 slots)
Figure 89: PCB view of card cage (2 slots) FCA2007-A1
1 1
1
1 1
1
To Next Page
Loading...
