Mounting and installation FC2080
Installing an Ethernet switch (MM) FN2008
6
323 |
Building Technologies
6.16 Installing an Ethernet switch (MM) FN2008
6.16.1 Installation
The Ethernet switch (MM) FN2008-A1 is installed vertically on a DIN rail. The
following example shows the installation on the DIN rail on the side wall.
Figure 180: Example of installation of the Ethernet switch in the FC2080
1 Ethernet switch (MM)
2 Additional DIN rail with terminal block (if required) and locking clamps
3 Carrier on the right-hand side wall
Example of installation
1. Install an additional DIN rail (2), if required with a terminal block and locking
clamps as shown in the example, on the carrier of the right-hand side wall (3).
2. Install the Ethernet switch (MM) (1) on the DIN rail (2).
3. Wire the Ethernet switch (MM) according to the planner's specifications.
The Ethernet switch wiring corresponds to the specifications of this module for the
compact control panels given earlier in this document. You will also find detailed
information regarding wiring and pin assignment of the electrical and optical
connections in the document 008837, Product data.
See also
2 Connecting the Ethernet switch [➙ 255]
1
2
To Next Page
Loading...
