Mounting and installation of the compact control panels
5
88 | 354
5.5 Fire terminal board
5.5.1 Installation
The fire terminal board FTI2002-A1 is already mounted in the fire terminal in the
factory and only has to be replaced in the event of a repair.
Prerequisites
● Components that make access to the periphery board difficult are removed.
● All connections and plug-in contacts are disconnected (label cables before
disconnecting them).
● The fire terminal board is removed.
Figure 38: Mounting of fire terminal board
1 6 fixing screws
2 Fire terminal board
3 Screw bushings on the rear panel
X1 Connector for power supply input
X3 Connector for the connection cable to PMI & mainboard (operating unit)
3
To Next Page
Loading...
