Mounting and installation of the compact control panels
5
89 |
Building Technologies
X5 Connector for power supply output Vsys
X6 Connector for supply input Vsys 2
X7 Connector for supply input Vsys 1
X400 Connector for periphery bus
Mounting steps
1. Mount the fire terminal board (2) with the six fixing screws (1) to the screw
bushings (3) that are embedded in the rear panel.
2. Wire up the fire terminal board according to the following pin assignment.
3. Re-install any modules that you may have had to remove.
To Next Page
Loading...
