Siemens FS20 - Installing the Battery Kit (9 V) [FR]; Installation; Wiring

Mounting and installation FC2080
Installing the battery kit (9 V) [FR]
6
326 | 354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
6.18 Installing the battery kit (9 V) [FR]
6.18.1 Installation
The battery kit 9 V FCA2010-F1 [FR] is a holder for a 9 V monobloc battery and is
required in France for maintaining emergency supply in the case of battery failure.
Figure 184: Installing the 9 V battery kit in the FC2080
1 Additional DIN rail with terminal block (if required) and locking clamps
2 Carrier on the right-hand side wall
3 Battery kit 9 V FCA2010-F1 [FR]
Example of installation
1. Install the battery kit (3) on a carrier of the right-hand side wall (2).
2. If required, install an additional DIN rail with terminal block (1) and locking
clamps on the right-hand side wall as shown in the example.
3. Connect the battery holder according to the following connecting chart.
6.18.2 Wiring
Connection of the 9 V battery kit to the card holder (CPU)
X10 Des. Connection
5 3SRC+ 3rd source (DC 7…30 V), positive pole, red
6 3SRC- 3rd source (0 V), negative pole, blue
Table 7: Pin assignment of the terminal X10 on the card holder (CPU)
1
2
3