Setup of the compact control panels
tation rear panels (packaging unit)
3
30 | 354
3.2.6 Mounting material
The following mounting material is supplied with all stations:
6 Rear panel screws Ø 6/40 mm
6 Nylon wall plugs Ø 4.5-6 mm
6 Cable ties 2.4 x 137 mm
5 Philips screws M 3/6
1
2 Philips screws M 3/12 (
2
2 Edge protection strip 40 x 100 x 1.5 mm
3 Trapezoid edge protection strip
4 Pole protection caps
2 Flat cable mounting
1 Installation plate
3
5 Aluminum sticker for the cover cap of the wall mountings
4
1 Pre-assembled connection cable for the batteries
1 2k2/500 mW resistance
3 3k01/500 mW resistance
3 1 kV/1 A diodes
1
There are three extra screws with the Eco and Standard housings.
2
Both M3/12 screws are required for cable strain relief if a thick supply cable is
used.
3
The installation plate must be affixed to the outside of the control panel housing
and must be clearly legible (EN 54-2). The installation number and the date of
commissioning must be added upon commissioning.
4
If the station is mounted on a combustible surface, the mounting holes must be
covered with the aluminum stickers (CE directive).
In addition, the following documentation is enclosed with the stations:
● Letter with feedback sheet (return fax)
● License agreement A5Q00021001
● Product insert for the station (mounting instructions) A5Q00015754
● Product insert for the power supply
To Next Page
Loading...
