Siemens FS20 - Mounting Plate; Install Mounting Plate

Mounting and installation of the compact control panels
Mounting plate
5
120 | 354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
5.12 Mounting plate
The mounting plate FHA2007-A1 is used to hold components that have to be
installed above the periphery board. It is supplied in a disassembled state and in a
separate packaging unit.
There are two different kinds of installation:
● Installation in the Standard and Comfort housings
● Installation in Large housing
5.12.1 Install mounting plate
Mounting plate FHA2007-A1 is delivered unassembled and must be assembled
prior to installation. The edge protector (included) can be slid onto the respective
edges of the mounting plate to protect the cables.
Figure 56: Example of installation of mounting plate FHA2007-A1 in housing (Comfort)
1 Threaded hole in rear panel for spacer
2 Spacers (2 pieces) for fixing the mounting plate
3 Top fixing screw with spring (pre-mounted)
4 Mounting plate
5 Bottom fixing screw with spring (pre-mounted)
1
2
3
4
5
12
6
7
89
10
11
1310