Siemens FS20 - Installing the Carrier (19, Option)

Mounting and installation FC2080
Installing the carrier (19", option)
6
278 | 354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
6.5 Installing the carrier (19", option)
The carrier (19", option) FHA2024-A1 is intended for the installation of smaller
modules and relays. To this end, it is equipped with two DIN rails that are fitted one
above the other.
Figure 149: Installing the carrier (19", option)
1 Mounting holes in rear frame
2 Mounting holes in carrier (19", option)
3 4 fixing screws M6 x 12 with cage nuts
4 Carrier (19", option)
1. Install the carrier (19", option) (4) on the rear frame (1) with four fastening
screws (3) and cage nuts.
2. Equip the carrier (19", option) with the intended modules.
3. Wire up the modules used according to the separate installation sheets.
1
2 3
4