Siemens FS20 - Shield Connection Terminal Blocks [DE]

Mounting and installation of the com
pact control panels
Shield connection terminal blocks [DE]
5
115 |
354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
5.9 Shield connection terminal blocks [DE]
Figure 53: Mounting of the shield connection terminal blocks
1 Shield connection terminal block
2 Terminal strip
3 Philips screws M 3/6
Mounting steps
1. Fasten the terminal strip (2) using the two screws (3) as follows:
2. Eco and Standard housings: Above the rectangular cable breakout opening on
the right
3. Comfort housing: One terminal strip above each of the rectangular cable
breakout openings
4. Hang the shield connection terminal blocks (1) onto the terminal strip (2) and
fasten them by tightening the knurled screws.
1
2