Siemens FS20 - Setup of Compact Control Panels; Packaging Units; Station Rear Panels

Setup of the compact control panels
Packaging units
3
21 |
354
Building Technologies
008851_s_en_
--
Fire Safety
20
16
-
01
-
27
3 Setup of the compact control panels
3.1 Packaging units
The stations can be delivered in several packaging units. Mounting and assembly
are carried out on-site.
The delivery consists of the following packaging units:
● Pre-installed rear panel, with periphery board, power supply, disconnect
terminal block and wiring
● Pre-installed operating unit with cover cap
● If ordered: Operating add-on with cover cap
● Options
When unpacking the station do not damage or dispose of the packaging.
The packaging includes a drilling template for the corresponding station housing.
The packaging of the rear panel can be used as protection after mounting to
protect the open station against soiling and damage.
3.2 Station rear panels (packaging unit)
The following chapters show views of the stations as they are delivered. The
design of the rear panels differs depending on the housing and the type of the
station.
You will find detailed information about the housing types and individual stations in
document 008836.
You will find detailed information about the individual components in document
008837.